If your loading dock was built with 9′ or 10′ openings then our Super Wedge dock seal might be for you. In some cases loading dock openings are built wider than the trailers that are used on them. The Z-Series Super Wedge dock seal is designed to project into these openings allowing the trailer to make an effective seal.

The Rotary Z-series Super Wedge Dock Seal is specially designed to economically seal the openings of 9′ or 10′ over-sized door widths.
A tight, effective weather-seal is made to the sides of the truck by flexing wedge-shaped pads projecting into the opening.
Each model in the Z-Series dock seals is designed with polyurethane foam vertical pads attached to a wood base, covered with the same combination of materials available on compression dock seals.
Headers are available with either a compression pad or a top-cap curtain designed to close the top to standard truck heights.
The covering material on Rotary dock seals is flame tested to meet federal standards and exceeds most tensile and tear strength requirements.
All Rotary dock seals are custom designed, complete with angle mounting brackets, air-exhaust ports and safety-yellow guide stripes.

SHOWROOM

90 Buck Road
Holland, PA 18966

Phone: 215.364.3730
Fax: 215.867.5313
Email: info@aarondoors.com

HOURS:

Mon-Fri - 8:00 a.m. - 5:00 p.m.

Sat - 8:00 a.m. - 2:00 p.m.

SHOP & COMPARE

24 hours Emergency Service Available

© 2017 Aaron Overhead Door Co. 

Digital Marketing by Potentia Digital